Published Paper


Characterization of C-4120 Steel Material Performance as Harbour Crane Handles

T. K. Jinyemiema, A. G. Des-Wosu and Akpan, Etuk Gabriel
Department of Mechanical Engineering, Rivers State University Nkpolu-Oroworukwo, Port Harcourt
Page: 726-739
Published on: 2026 September

Abstract

Introduction: The continuous evaluation and optimization of container handling components at ports are essential due to the extreme loads and harsh wear conditions they must endure. Crane handles serve as primary interfaces for maneuvering heavy cargo. Objectives: This study aims to evaluate and optimize the material performance of AISI C-4120 steel for use as harbour crane handles under varying heat-treated and simulated loading conditions. Methods: Chemical validation was performed using Positive Material Identification (PMI), an X-Met 7000 analyzer. The mechanical properties were evaluated by standard tensile testing and non-destructive Leeb rebound hardness testing across three states: as-received, water-quenched (400°C), and furnace-cooled annealed (580°C). A baseline structural load configuration was used to perform numerical validation through ANSYS Finite Element Analysis (FEA). Results: PMI confirmed elemental compliance (Chromium: 0.40–0.60%, Molybdenum: 0.13–0.20%). Water quenching elevated the ultimate tensile strength from 428 MPa to 506 MPa (+18%) and surface hardness from 370 HL to 406 HL (+10%). Under a normalized baseline load of 800 N, the quenched handle exhibited a maximum structural deformation of 3.2515×10-6mm and peak von Mises stress of 1.5133×107Pa. This reflects a 28.5% decrease in structural deformation and a 24.5% decrease in localized peak von Mises stress compared to the annealed configuration. Conclusion: A controlled water-quenching process should be implemented to optimize the material profile of C-4120 steel for high load-bearing capacity and safety under various operating conditions to prevent wear and structural damage in marine crane logistics.

 

PDF